Classic 5-Stage R.O Water System 75GPD with Pump & Pressure Tank

5 Stage R.O. Filtration System

• 5-micron PP sediment pre-filter to filter suspended particles such as dirt, sand, rust, etc.
• 1-micron PP sediment pre-filter to filter suspended particles such as dirt, sand, rust, etc.
• Carbon block filter to reduce free chlorine, chloramines, chlorine taste and odor.
• High-production 75gpd R.O. membrane encapsulated element to reduce dissolved solids, metal ions, bacteria & viruses and other suspended particles as small as 0.0001 micron.
• Water conditioning combo post-filter.

 

Pressure Switches: The system is equipped with pressure switches. The low pressure switch shuts off the pump when there is no inlet water or its pressure is too low. The high pressure switch shuts off the pump when the filtered water faucet is turned off.

 

Booster pump: it offers the advantages of favorable wastewater-treated water ratio (about 3: 1), operation in places with lower water pressure (smaller settlements, homesteads, 10th floor) and offers faster tank filling.

 

Faucet:  Designer faucet for filtered water is included and usually mounted on the sink deck or countertop for dispensing the clean, filtered water from the filtered water outlet of the main R.O. unit.

 

Drain Saddle: Fits a standard 1.5” diameter drain pipe to drain the waste water from the drain outlet of the pump box.

 

Pre-Filters: The main R.O. unit has three pre-filters: two sediment pre-filter on the first stage and activated carbon pre-filter on the second stage. They provide initial filtration of the water and protect the following thin film composite R.O. membrane from dirt and aggressive chemicals such as chlorine often found in tap water.

 

R.O. membrane: The fourth and main stage of the filtration is high-production R.O. membrane. It is “semi-permeable”, which means that it allows water to pass through but prevents dissolved particles from passing through. It splits the feed water into two streams: clean water goes to the post-filter and then onto the faucet. Waste water with rejected particles goes down the drain.

 

Post-Filter: Last stage of filtration is an activated carbon post-filter for fine conditioning and keeping the extra  freshness of your water.

 

TDS Blending Valve: Many times there is the desire to raise the total dissolved solids (TDS) of our filtered water. This is due to the fact that the purified water produced by the reverse osmosis water systems have usually a TDS value of ~25-35 ppm. For the best drinking water quality and personal well-being it is recommended that the TDS value should be ~80-150ppm. To achieve a TDS value in that range we use a TDS blending (mixing) valve.  

 

TDS blending is incredibly simple and involves mixing your filtered water (water filtered by the first two pre-filters: GAC and sediment) with the R.O water to achieve a TDS that's desirable to your needs and taste. Since the water sytem already includes the two pre-filters, the feed line between the pre-filter system and the R.O pump is tapped and as mentioned above the filtered water (not raw water), is mixed/blend with the purified R.O water in order to produce the desired TDS value.

 

The by-pass blending (mixing) valve installed in the device ensures the proper repatriation of the minerals. The set-up of the blending valve is recommended to be set by a specialist when installing the water purifier.

• 5-stage filtration water system that you can easily add additional filters or a UV lamp.
• 12 litre metal tank 
• Pressure switches to start and turn off the system automatically.
• External power adapter
• Reduces TDS by 20 times because of the large and high rejection rate membrane and more powerful pump. 
• Clean and safe drinking water right in your home. No need to transport and dispose of bottled water any more.
• Pre-installed filters and membrane for faster and easier setup.
• Filters and membrane quick-change housings for easy maintenance.
• Compact design.
• Booster pump increases pressure to radically improve the performance and effectiveness of the R.O. unit in all three key areas: increases filtered water flow (production rate), increases rejection rate (improves water purification quality), increases recovery rate (decreases amount of waste water). Prolongs the membrane and pre-filter(s) service life due to increased recovery rate.
• Fully automatic operation of the water system: just open the faucet and get clean water instantly.
• Split, flexible installation possible where needed: install the faucet up to 15 meters away from the R.O. unit itself. Useful for the situations like lack of space or lack of electrical outlet under the sink or moving the unit to a more appropriate place.

Benefits of the R.O. system

• 5-stage water filtration system
• Its reverse osmosis system works with one of the best quality membranes on the market (PENTAIR) to produce the best possible water quality.
• Due to its small size, it can be easily placed under the counter. It is suggested to place the pressure tank under the counter.
• Its modern faucet can fit in any kitchen.
• Easy to install, but you can always ask for the help of our specialist.
• It is easy to maintain and allows you to easily change the filters by yourself (drop-in).
• It can work with low pressure (1 bar)
• Place of Origin: EU

 

Advantages of booster pump operation: favorable wastewater-treated water ratio (about 3: 1), operation in places with lower water pressure (smaller settlements, homesteads, 10th floor), and faster tank filling.

• Multi-Stage Filtration Unit box
• Polypropylene 5 micron pre-filter
• GAC pre-filter
• Polypropylene 1 micron pre-filter
• Reverse osmosis membrane (75 GPD PENTAIR)
• Quick connect type in-line post-filter.
• Connectors & fittings
• Designer Faucet
• Pressure tank 12L
• Installation Kit

Technical parameters:

• Operation pressure: 1-5 bar with pump
• Maximum water salanity: 2000 ppm (mg/l)
• Temperature of feeding water: 2-38 °C
• Permissible water pressure: 3 - 7 bar

 

Capacity: Maximum capacity 275 liters / day.

 

Notice: The quality of the treated water depends on the pressure, contamination and temperature of the water to be treated. One important thing: the water purifier removes contaminants for approx. It filters out 95% of the water! It collects only a few percent of these contaminants, while flushing almost all of the contaminants back into the sewer system! This is the best working water purification method in the world today!

The water system has a Hungarian ÁNTSZ expert opinion and an OTH license. OTH license number: KEF-7265-2 / 2015. The production of the filters has been certified under the international standards ISO9001:2015 and ISO14001:2015.

 

EC Declaration of Conformity

• 2011/65/EU
• 2014/30/EU
• 2014/35/EU

Standards applied:
• EN 50563:2011+A1:2013
• EN 61000-6-1:2019
• EN 61000-6-3:2007+A1:2011
• EN IEC 63000:2018

 

Year in which CE marking was first affixed: 2017

Size of the water system : 330 x 430 x 160 mm (WxHxD)

Tank dimension (h x diameter): 430 x 280 mm

Shipping Weight: 13 kg (with pump)

System Maintenance

 Filter 1: 5 micron "DROP IN" sediment pre-filter

Filter 2: 1 micron "DROP IN" sediment pre-filter

Filter 3: activated carbon (GAC) pre-filter "DROP IN"

Filter 4: 75 GDP Pentair reverse osmosis membrane

Filter 5 :  activated carbon post-filter

It is advisable to replace the three pre-filters (1st, 2nd, 3rd) and activated carbon post-filters (5th) every 6-12 months depending from your water quality.

 

ATTENTION: Please note that the safe operation of the device requires proper professional filter replacement and maintenance.

3 years worldwide limited warranty (+ local regulations if applicable).

 

Product must be installed only by trained service professionals. Only original replacement parts, filter cartridges and accessories made by manufacturer may be used.